Industrial coatings - metal conditioner

Endura Manufacturing Co. Ltd. TEL 1-800-661-9930 DX Metal Treatments are specifically designed to condition and refinish metals for maximum adhesion and corrosion re Suitability
Theoretical Solids
Content:
DX579: Metal Cleaner
DX579 is a multi-purpose phosphoric acid based cleaner and prepaint cond most metals. It can be used to deep clean a metal surface prior to paint or Shelf Life*
surface for a subsequent chemical coating. DX579 is blue in color and co DX520: Metal Conditioner
DX520 is a phosphoric acid based coating chemical that will produce a zinc phosphate Pot Life of Mixed
coating on galvanized or steel surfaces. DX520 contains a small amount of detergent Product:
which aids in the removal of light soils and oils and promotes the formation zinc phosphate coating. DX520 is pale green in color and may turn darker DX533: Aluminum Cleaner
DX533 is a phosphoric acid based cleaner, brightener and prepaint conditi aluminum. It is used to deep clean and brighten an aluminum surface prior painting, or to prepare the surface for a subsequent chemical coating. DX533 is clear in
DX503: Aluminum Conditioner
DX503 is a chromic acid based chemical that will produce a chrome conver on aluminum and its alloys. The coating formed by DX503 is gold to tan a part of the aluminum surface. DX503 is medium orange in color and ma DX501: Aluminum Conditioner
X501 is a clear version of DX503. The coating formed by DX501 is clear in color. It is used when it is desirable to retain the silver white aluminum finish, either unp with a clear finish over the chemical coating. Dilution with hot water may c color of DX501 coating to a darker shade similar to DX503. DX501 is light NOTE: If applying Wash Primer to clean bare metal substrates, metal etch pretreatment is not
required or advisable. Metal treatment is not recommended or advisable on sandblasted metal. Endura Manufacturing Co. Ltd. is committed to ongoing product development to provide the best products. New materials, production methods and design refinements are introduced into existing products without notice. For this reason, any current Endura product may differ in some respect from its published description. It is always warranted to equal or exceed the original design specifications, unless otherwise stated. Endura Manufacturing Co. Ltd. TEL 1-800-661-9930 DX Metal Treatments are specifically designed to condition and refinish metals for maximum adhesion and corrosion resistance. Application Procedure
Theoretical Solids
Content:
Shelf Life*
Prime with DPLF Epoxy Primer in the same day. Pot Life of Mixed
Product:
NOTES: 1. Read the printed instructions on the container prior to use. 2. For optimal results with Metal Cleaner DX579 or Aluminum Cleaner DX533, apply chemicals with acid resistant brush or synthetic abrasive pad (i.e. Ultra Fine Scotchbrite). 3. When treating galvanized or galvaneal metal always use an abrasive pad. Caution/Safety

Before opening the package, be sure you understand the warning label. Improper spray
technique may result in a hazardous condition. Follow spray equipment manufacturer’s
instructions to prevent personal injury or fire. Follow directions for respirator use. Wear
eye and skin protection. Observe all applicable precautions.
Endura Manufacturing Co. Ltd. is committed to ongoing product development to provide the best products. New materials, production methods and design refinements are introduced into existing products without notice. For this reason, any current Endura product may differ in some respect from its published description. It is always warranted to equal or exceed the original design specifications, unless otherwise stated.

Source: http://www.endura.ca/pdf/TDS/metalconditionerdx520.pdf